Dell PowerConnect 8024 Upgrading Firmware page 18

Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or
4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware
2. Download the 5.1.9.3 firmware from a TFTP server.
console#copy tftp://10.10.10.200/PCM6220v5.1.9.3.stk image
Transfer Mode.................................. TFTP
Server IP Address.............................. 10.10.10.200
Source File Path............................... /
Source Filename................................ PCM6220v5.1.9.3.stk
Data Type...................................... Code
Destination Filename........................... image
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
TFTP code transfer starting
11517952 bytes transferred
Verifying CRC of file in Flash File System
Unpacking the image file.
Distributing the code to the members of the stack!
File transfer operation completed successfully.
console#show version
Image Descriptions
image1 : default image
image2 :
Images currently available on Flash
--------------------------------------------------------------------
unit image1
--------------------------------------------------------------------
1 5.1.9.3
3. Activate the
5.1.9.3
console#boot system image1
Activating image image1 ..
4. Update the boot code and reboot the switch.
console#update bootcode
Update bootcode and reset (Y/N)?y
Updating boot code ...
BootCode from image1
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..................................BCM56314 DEV REV ID = 0001b314
a. If using the serial port to update the firmware, the following output will be observed. If logged in
via telnet or SSH, rebooting the switch will close the connection. Rebooting may take several
minutes to complete and the switch may reboot itself autonomously during the upgrade procedure.
image2 current-active
2.2.0.3 image2
firmware
Page 15
next-active
image2