Adaptec 2940W Installation Manual page 9

For situations where you might want or need to
change the settings, see the descriptions of each set-
ting in the user's guide. If you need to change any of
the default settings, or if you would like to format or
verify a disk, see Starting the SCSISelect Utility on
page 9 to start the utility.
Basic Host Adapter Settings
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Boot Device Settings
Boot Target ID
Boot LUN Number
SCSI Device Settings
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
Send Start Unit SCSI Command
Advanced Host Adapter Settings
Plug and Play SCAM Support
Host Adapter BIOS
Support Removable Disks Under BIOS as Fixed Disks
Extended BIOS Translation for DOS Drives > 1 GByte
Display <Ctrl-A> Message During BIOS Initialization
Multiple LUN Support
BIOS Support for More Than 2 Drives
BIOS Support for Bootable CD-ROM
BIOS Support for Int 13 Extensions
1
Applies to AHA-2940 only
2
Applies to AHA-2940W only
3
Setting is valid only if Multiple LUN Support is enabled
4
Settings are valid only if host adapter BIOS is enabled.
3
2
4
4
4
4
4
8
Default
7
Enabled
Automatic
Low ON/
2
High ON
Default
0
0
Default
Yes (Enabled)
10 MBytes/sec
Yes (Enabled)
Yes (Enabled)
No (Disabled)
Default
Disabled
Enabled
4
Boot only
4
Enabled
4
Enabled
Disabled
Enabled
Enabled
Enabled
1
;