Table of Contents
Advertisement
14.5 Disposal
Dispose of device components and packaging materials in an
environmentally friendly manner in accordance with the country-
specific waste treatment and disposal regulations.
Safety instructions
Please read the following safety instructions and mounting chapter 2 before instal-
lation and keep these instructions for future reference.
Improper use or operation may result in personal injury
and/or property damage.
Control of the device
The devices are checked before shipment and shipped in perfect condition. If any
damage is visible on the device, we recommend a precise inspection of the transport
packaging. In case of damage, please inform the supplier immediately.
15. Installation
Only technicians, who are familiar with the technical terms, warnings, and instructions
in the manual and who are able to follow these, should connect the device.
Should there be any doubt as to the correct handling of the device, please contact
your local distributor. However, you can also contact promesstec GmbH directly.
Mounting and connection of the device should comply with national legislation for
mounting of electric materials, i.e. wire cross section, protective fuse, and
location. Descriptions of input / output and supply connections are shown in the block
diagram and side label.
The following apply to fixed hazardous voltages-connected devices:
The max. size of the protective fuse is 10 A and, togehter with a power switch, it
should be easily accessible and close to the device. The power switch should be
marked with a label telling it will switch off the voltage to the device.
promesstec GmbH I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
E-Mail: office@promesstec.com I Internet: www.promesstec.com
28
Advertisement
Table of Contents
