Installation - Inalto Classique IFLW9 User Manual

INSTALL ATION
UNPACKING THE WASHING MACHINE
Unpack your washing machine and check if there is
any damage during the transportation. Also make
sure that all the items in the attached bag are
received.
If there is any damage to the washing machine
during the transportation, or any item is missing,
please contact the local dealer immediately.
DISPOSE THE PACKING MATERIALS
The packing materials of this machine may be
dangerous to kids. Please dispose them properly
and avoid easy touch by kids. Please dispose the
related packing materials according to the relevant
local regulations. Please do no throw the packing
materials away together with the other daily living
rubbishes.
REMOVE TRANSPORT BOLTS
Before using this washing machine, transport bolts
must be removed from the backside of this machine.
Please take the following steps to remove the bolts:
1. Loosen all bolts with spanner and then remove
them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
→
SELECT THE LOCATION
Before installing the washing machine, the location
characterized as follows shall be selected:
→ Rigid, dry, and level surface (if not level, please
make it level with reference to the following
figure "Adjust Leg")
→ Avoid direct sunlight
→ Sufficient ventilation
→ Room temperature is above 0 C
→ Keep far away from the heat resources such as
coal or gas. Make sure that the washing machine
will not stand on power cord.
→ Do not install the washing machine on the
carpet floor.
ADJUST LEG
1. When positioning the washing machine, please
first check if the legs are closely attached to the
cabinet. If not, please turn them to their original
positions with hand or spanner and tighten the
nuts with spanner.
2. After positioning the washing machine, press
four corners on top cover of washing machine in
sequence.
If the washing machine is not stable when being
pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing
machine. Loosen the lock nut with spanner and
turn the leg with hand until it closely contacts
with the floor. Press the leg with one hand and
fasten the nut closely to the cabinet with the
other hand.
→
4. After being locked properly, press four corners
again to make sure that they has been adjusted
properly. If it is still unstable, it has to repeat
Steps 2 and 3.
5. Put a solid cylinder (e.g. pop cans) oppositely on
the top cover of the washing machine from in
the left, right, front and back directions. If the
cylinder keeps stable, the washing machine is
positioned level. If it rolls, the washing machine
is positioned unlevel. The rolling direction is the
direction of lower ground surface. Then, the two
legs in this direction shall be raised at the same
time until the washing machine is level. Steps
1–3 are repeated to make the bottom legs closely
against the ground and the nuts shall be locked
tightly.
CONNECT INLET PIPE
Connect the inlet pipe as indicated in the figure.
For the model which has hot valve , please connect
the hot vale to hot water tap. Energy will decrease
automatically for some program.
→
6