Advertisement
Chapter 1.
Before installing the router, you should have connected your PC to the Internet
through your broadband service successfully. If there are any problems, please
contact with your ISP. After that, please install the router according to the following
steps. Don't forget to pull out the power plug and keep your hands dry.
a. Power off your PC(s), Cable/DSL modem, and the router.
b. Locate an optimum location for the router. The best place is usually near the
center of the area in which your PC(s) will wirelessly connect.
c. Adjust the direction of the antenna. Normally, upright is a good direction.
d. Connect the power adapter to the power socket on the router, and the other
end into an electrical outlet. The router will start to work automatically.
After finishing the steps above, please choose the operation mode you need and
carry out the corresponding steps. There are three operation modes supported by
this router: Standard Wireless Router, Repeater and WISP Client Router.
1.1 Standard Wireless Router Mode
The default mode of the router is Wireless Router. On this mode, it can be
connected to Cable/DSL Modem or directly connected to a wired network with an
Ethernet cable. Computers can connect to the device by both wired way through
the wired port LAN and wireless way.
a. Connect the PC(s) to the LAN Ports on the router.
b. Connect the DSL/Cable Modem to the WAN port on the router.
c. Power on your PC(s) and Cable/DSL modem.
Connecting the Router
1
Advertisement
