Using Buttons - Marco SCS 165 20 415 Instructions For Use Manual

The panel has four buttons, with the following functions:
«ON/OFF» button: manual Standby Enable / Disable
«RESET» button: error Reset
Tab.1 EN
BUTTON
ON/OFF
RESET
ON/OFF+RESET
To enter the brightness setting mode of the Leds quickly press once and
simultaneously both keys. Press the "reset" key to increase brightness and
press the "on/off" key to decrease it. To confirm the new setting press both keys
once again.
«TURTLE» button: enables Oil mode.
«HARE» button: enables Diesel mode (Default Speed).
Speed reduction is obtained by briefly pressing the key of the mode currently in
use until the desired speed is reached: the setting is then saved and, by
selecting the mode (oil or diesel), the speed will be the last one saved.
A long press on both buttons toggles the "NO LIQUID" function.
This function turns the pump off after 90 seconds with low current draw: this
helps protect the pump from running dry, but it could be disabled with low
viscosity fluids, in oil mode, to prevent unwanted turn-offs. In this case, liquid
presence should be assured to prevent damage to the pump.
When the "NO LIQUID" function has been disabled, the blue LED on the
pressure sensor stays always OFF (to notify the particular condition), either in
the presence or absence of liquid in the pump. On the panel the blue led is
blinking, because its status is no longer updated. Under this condition the
responsibility for the pump-turn off lies entirely with the user.

USING BUTTONS

TIME SHORT TIME PRESS
Standby Enable / Disable
Pump and Panel Reset
Brightness Change
9
©
LONG TIME PRESS (> 1,5 s)
S.p.A.
ENG
No Action
No Action
No Action
(follows)