Acer P7500 Series User Manual page 37

Timeout(Min.)
Once "Security" is activated to "On", the administrator can set
timeout function.
•
•
•
•
•
User password
•
•
•
•
•
•
•
Administrator Password
The "Administrator Password" can be used in both the "Enter
Administrator Password" and "Enter Password" dialog boxes.
•
•
If you forgot your administrator password, do the following to
retrieve the administrator password:
•
•
•
VGA OUT (Standby)
•
Auto Screen
Reset
•
Press or to select the timeout interval.
The range is from 10 minute to 990 minutes.
When the time is up, the projector will prompt the user to
enter the password again.
The factory default setting of "Timeout(Min.)" is "Off".
Once the security function is enabled, the projector will
request user to enter password when switch on the projector .
Both "User Password" and "Administrator Password" can be
accepted for this dialogue.
Press to setup or change the "User Password".
Press number keys to set your password on the remote control
and press "MENU" to confirm.
Press to delete character.
Enter the password when you see "Confirm Password"
displayed.
The password should be between 4 and 8 characters long.
If you select "Request password only after plugging power
cord", the projector will prompt the user to enter the
password every time the power cord is plugged.
If you select "Always request password while projector turns
on", the user has to enter the password every time when the
projector is turned on.
Press to change the "Administrator Password".
The factory default of "Administrator Password" is "1234".
An unique 6-digit "Universal Password" which is printed on
the Security Card (please check accessory in the box). This
unique password is the number which will be accepted by
projector anytime no matter what the Administrator
Password is.
If losing this security card and number, please contact with an
Acer service center.
Default is "Off". Choose "On" to enable VGA OUT
connection.
Default is "On", the down/up move of electronic screen will
be related with power on/off of Projector.
Press the button and choose "Yes" to return the
parameters on all menus to the factory default settings.
27