Download Print this page

GE SS-131ER Installation And Operating Instructions Manual page 2

Environmental radiation monitor

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
1.0
MECHANICAL
While the RSS-131ER is a portable device, it may also be permanently mounted in any
orientation with suitably designed brackets and is not sensitive to detector orientation.
Generally, the RSS-131ER will be mounted with the cable connectors facing down. The
integral mounting flange on the "top" surface of the enclosure is compatible with tripod-type
mounting systems, and will accept #10"-24 machine threaded screws or bolts. Grounding of
the RSS-131ER is accomplished at a grounding point on the mounting flange by means of a
screw and lockwasher. This screw is identified by a grounding symbol
sticker with the symbol
Consult local electrical codes or normative references.
HPIC Dimensions Relative to Center of Ion Chamber
2.0
BASIC CHECKOUT/SETUP
Connect S131-232-002 cable to COM2 and PC.
Start configuration utility.
Power on unit.
Verify communications by selecting online...version.
Configure as desired, per the manual.
Remove the cable and mount as desired per manual and local regulations.
. In normal operation, grounding of the unit is not required.
3.0
ELECTRICAL
Cable to connect external 6 to 8 V
power supply to External Power
connector on RSS-131ER
Used only if no internal battery.
Switchcraft Part
#EN3C6F
RS #CN7-11
4.0
COM PORT CONFIGURATION / DATA STORAGE
The RSS-131ER is configurable through the RSS-131ER configuration utility. Communications,
as original shipped from the factory, are as shown in the table 1. Configuration is done
through COM2 or COM4, using the S131-232-002 cable. Make sure the cable is attached to
the unit.
Table 1
COM Port
Baud Configuration
COM1
9600,N,8,1
COM2
9600,N,8,1
COM3
9600,N,8,1
COM4
9600,N,8,1
S131-232-002 Serial Cable to connect Data Acquisition Board COM 2 to PC DB-9
Switchcraft 4 pin connector
(Female connector on cable)
Switchcraft Part #ENC4F
To power supply
To ground on power supply
2 conductor 22 ga cable should be
used. Alpha part number
5610B2001(recommended).
(Optional internal modem)
DB-9 on PC
(Female connector on cable)
Panel Legend

Advertisement

loading