Ignite MARGAY racing K3 Setup Manual page 7

2015 IGNITE K3 SET-UP
BASELINE SET-UP INFORMATION FOR THE IGNITE K3
GENERAL MAINTANENCE (CONT)
At the completion of each days racing
Remove the float bowl on the carburetor and
sessions, be sure to pull the carburetor drain
break clean the brass jets that are screwed
plug screw to empty the float bowl. This will
into the housing. This will help ensure your
help limit required maintenance on the
engine is running at the optimum level.
carburetor in the future.
Check header bolts after each run to ensure
Check and tighten the axle bearing set
they are always tightly fastened. Also check
screws after each on track session. This helps
header mounting bolts, brackets, silencer,
ensure that the axle stays in position and
and silencer clamp.
doesn't move under load on track.
Page 6 of 29