Table of Contents
Advertisement
Value
Going Up
Up
Going Down
Temporary Down
Table 3. HSTR Port Configuration: Status Values
Operation Mode
Sets the operation mode of the port, possible configured values are FDX port , FDX
station and Auto. On an HSTR connection, one end must be a FDX port and the
other a FDX station. An HSTR adapter is always a FDX station, where as a switch
port can be both. The Auto mode will attempt to detect the port mode automatically
by switching between the two modes with a period of a few seconds.
When the port connects in the Auto mode, the detected mode is shown as A-FDX
port or A-FDX station.
Default: Auto .
Cfg Loss Threshold
Sets the number of configuration losses before the port auto-disables. Possible
values are 1 to 100 or Disabled . The MAC protocol generates a configuration loss
in case of lobe test failure, heartbeat failure, address change or other MAC protocol
error.
Default: 8 .
Cfg Loss Sampling Interval
Sets the sampling interval in which the Cfg Loss threshold must be exceeded for
the port to auto disable. Possible values are 1 to 60 minutes.
Default: 1 .
Address Demand Aging Level
Sets the threshold on the number of entries in the address table on which entries are
aged faster. Possible values are 50, 60, 70, 80 and 90 percent and Disabled .
Default: 90 percent.
CrossFire 8650/8651 UEM Guide to Operation, DOC-7090 v. 1.0
Meaning
The port is enabled and the MAC
protocol is trying to connect.
The port is up and the MAC protocol
has connected.
The port has been disabled and the
MAC protocol is disconnecting.
The MAC protocol has disconnected,
but is actively trying to connect again.
The disconnect reason might be a wire
fault or configuration change.
17
3. Console Configuration
Advertisement
Table of Contents
