JVC MC-8200LU Service Manual page 8

3. Grasp the grip to remove the magazine toward you.
4. When loading the magazine, insert the magazine gently until
it clicks.
2.1.4 Removing the Drive
1. Open the door. (Refer to 2.1.2.)
2. Remove the rear panel (DH). (Refer to 2.1.8.)
3. Disconnect the two connector cables from the drive.
4. Disconnect all the SCSI cables from all the drives and the
SCSI PCB. (When removing the drive in the uppermost slot
among the currently mounted drives, disconnect the cable
connected to the uppermost drive only.)
Photo shows situation when removing the Drive 2
SCSI cable Connector cable
1
5. Remove the screw located on the side of the drive (door
panel side).
Photo shows situation when removing the Drive 2
Grip
1
6. Remove the drive from the rear.
2.1.5 Removing the Center Panel
1. Open the door. (Refer to 2.1.2.)
2. Remove the panel. (Refer to 2.1.2.)
2
3. Remove the six screws
Note:
Center panel must be removed when removing the car-
rier mechanism.
to remove the center panel.
2
6 screws
2-4