JVC MC-8200LU Service Manual page 15

1
Demonstration Mode
(1) Purpose
This mode is used to perform a demonstration of the CD/DVD changer operation.
(2) Start
While pressing the "ENTER" key and the numeric key "3" simultaneously, turn the power ON.
* It is not necessary to set the discs on each tray. (A disc presence check is not performed.)
(3) Operation
Repetition of crossing operation.
Disc Access (MC-8200U: when drives 1 and 2 are connected)
• Crossing Operation
Count
0001 "200" → DR1
0002 "001" → DR2
0003 "199" → Mail slot
0004 "002" → DR1
0005 "198" → DR2
0006 "003" → Mail slot
0099 "101" → DR1
0100 "100" → DR2
(4) Operation Stop
When the numeric key "3" is pressed during demonstration, the operation stops after the disc being accessed is returned to the
original magazine.
(5) Operation Restart
When the "ENTER" key is pressed in the demonstration-stop mode, the operation restarts from the tray next to the one being
accessed the previous time.
2.2.2 Access Counter Clearance
1. Set to display the contents shown on page 29 of the instruction manual.
2. Hold the SELECT key until the unit to be cleared appears in the 1st line.
3. With the unit counter to be cleared shown on the 1st line, hold the ENTER key for more than 5 seconds.
2.2.3 Manual Operation
M A N U A L
S E L E C T : 0 0
ENTER
M A N U A L
2-11
Access Address
→ "200"
→ "001"
→ "199"
→ "002"
→ "198"
→ "003"
→ "101"
→ "100"
M O D E
Select SUBMODE using the numeric keys
(00 - 07,
After selecting, press ENTER key
M O D E
0 0
Pressing numeric key 1 - 5 activates the corresponding operation
(refer to the table on the next page).
0 - 1; : 1 - 4)