Page 3
Validity These instructions for use are valid for the following device: Device Order no. SLF-100-W5K7-P-24V 1-33-346 Product Identification Designation Description Compact spot light - Attachment optics with frosted lens Luminous field diameter in mm at 200 mm Working distance W5K7...
SLF-100-W5K7-P-24V Table of Contents TABLE OF CONTENTS 1 Information about the Instructions of Use..........5 1.1 Intended Use....................5 1.2 Improper Use....................6 1.3 Qualified Personnel..................6 1.4 Warranty and Liability...................7 2 Safety......................8 2.1 Presentation of Safety Instructions.............. 8 2.2 Safe Handling of the Device................ 9 3 Scope of Delivery and Accessories............
SLF-100-W5K7-P-24V Information about the Instructions of Use 1 INFORMATION ABOUT THE INSTRUCTIONS OF This document contains technical information, important instructions for correct installation, commissioning and use, as well as product information which were up-to-date at the time of going to press.
SLF-100-W5K7-P-24V Information about the Instructions of Use 1.2 Improper Use All unintended use and all device-related activities not described in these instructions of use is to be deemed as unauthorised misuse outside the legal limits of indemnity of the manufacturer.
SLF-100-W5K7-P-24V Information about the Instructions of Use 1.4 Warranty and Liability The contents of this document have been checked carefully and correspond to current legislation and best practise at the time of going to press. However, the manufacturer shall not be liable for any damage arising from the use of this edition of the manual, and rejects any warranty derived therefrom.
SLF-100-W5K7-P-24V Safety 2 SAFETY 2.1 Presentation of Safety Instructions Each safety instruction is introduced by a key word and colour highlighted. The key word indicates the degree of danger. The danger and its cause are described, and then the measures to prevent conceivable consequences of the danger.
SLF-100-W5K7-P-24V Safety 2.2 Safe Handling of the Device Read the following applicable safety instructions carefully and completely. Follow the instructions for your own safety, the safety of other people, and to avoid damage to the device and the connected technical equipment. Hazards going beyond the general safety instructions are referred to separately at the relevant points in this manual.
Because of the many possible configurations, the cables are listed in the accessories rather than included in the scope of delivery. 3.1 Scope of Delivery Designation Quantity Device SLF-100-W5K7-P-24V Instructions for Use SLF-100-W5K7-P-24V 3.2 Accessories Connection cable M8-4-pin, straight plug, 4A, 60V Designation Description Order no.
Page 11
SLF-100-W5K7-P-24V Scope of Delivery and Accessories Connection cable M8-4-pin, straight plug, 5A, 30V Designation Description Order no. Connection cable Connection cable with 4-pin M8 socket 1-11-611 M8-4pin, 1m and open cable end with wire-end ferrules, 4 x 0.5 mm², 5A, 30V, PUR,...
SLF-100-W5K7-P-24V Technical Data 5 TECHNICAL DATA 5.1 General Parameters Parameter Characteristic Housing material Aluminium, black anodised Optical material Polycarbonate frosted Housing dimensions 54 mm x 32 mm x 21.5 mm (without connector) Dimensions light-emitting Diameter: 24 mm surface Filter thread M28 x 0.5 / depth 4.5 mm...
SLF-100-W5K7-P-24V Technical Data 5.2 Electrical Parameters Parameter Operating voltage U 19 V 24 V 29 V Power consumption at U = 24 V DC 2.5 W 3.0 W 3.5 W Switch input Input voltage OFF 2.0 V ON/OFF Input current OFF 0 mA 0.2 mA...
SLF-100-W5K7-P-24V Technical Data Spectral Emission Wavelength [nm] Image 2: Spectral emission 5.4 Conditions for Operation, Storage and Transport Observe the specified ambient conditions when transporting and storing the device. For accessories, connected devices and components observe the specific information in the associated instructions for use.
SLF-100-W5K7-P-24V Commissioning 6 COMMISSIONING NOTICE Installation and connection operations may only be performed in the off and de-energised state. 6.1 Unpacking 1. Lift the cardboard, together with the device, out of the carton. 2. Fold out the tucked in sides on the bottom of the cardboard. The film loosens and forms an insertion pocket.
SLF-100-W5K7-P-24V Commissioning 6.3 Connecting NOTICE Cable damage • Comply with the specified minimum bending radius. • Cables must generally be mounted with a strain relief clamp. • Use cables corresponding to the specification (see data sheet). 6.3.1 Pin assignment Use the M8 connector to connect the device according to the pin assignment.
SLF-100-W5K7-P-24V Operation 7 OPERATION WARNING Possibly hazardous optical radiation emitted from this product • May be harmful to the eye. • In case of operation do not look into the lighting for a long time. CAUTION Physiological effects by flashing lights •...
SLF-100-W5K7-P-24V Operation 7.1 Making Operational Readiness The device is switched on by applying the operating voltage. The device is switched off by disconnecting it from the operating voltage supply. 7.2 Operating Modes The integrated controller supports the following operating modes: •...
SLF-100-W5K7-P-24V Maintenance and Service 8 MAINTENANCE AND SERVICE 8.1 Maintenance The device is maintenance-free. Depending on the operating environment, it may have to be cleaned. The housing can be cleaned according to the conditions applicable to the given protection class.
SLF-100-W5K7-P-24V Maintenance and Service 8.2 Service Technical Support Please contact our technical support if you have any technical questions concerning our products. We will be glad to be of service: Monday to Thursday 8:00 to 17:00, and Friday 8:00 to 15:00.
SLF-100-W5K7-P-24V Disposal 9 DISPOSAL The device and its accessories and packaging must be sent to environmentally compatible recycling. Do not throw electrical devices or tools into the household waste! According to European Directive 2012/19/EU on waste electrical and electronic equipment and its implementation in national law, unusable electric tools must be collected separately, and sent to environmentally compatible recycling.
D-98527 Suhl, Germany Representative: Dr. Jürgen Geffe, Managing director We, Vision & Control GmbH Suhl, declare that the product described below – Designation: SLF-100-W5K7-P-24V – Order no.: 1-33-346 has been manufactured in accordance with the following standards and normative documents: •...
Need help?
Do you have a question about the SLF-100-W5K7-P-24V and is the answer not in the manual?
Questions and answers