LG LRG3193ST Service Manual page 25

REMOVING THE CONVECTION AN BLADE AND FAN MOTOR
1. Turn off the electrical supply and gas supply
going to the range and remove the oven racks.
2. Remove the four Fan cover screws and set the
fan cover aside.
3. To remove the fan blade :
- Remove the nut by
screwing clockwise. The
fan blade can be replaced
from inside oven.
COMPONENT ACCESS
3 screws
Nut
• Be careful not to bend the fan blade
- Failure to do so can result in vibration, noise,
and poor performance of convection when
operating.
4. To remove the fan motor assembly :
a) Pull the range out of its mounting location so
that you can access the rear of the unit.
b) Remove the rear panel from the unit (See step
5~6 on page 3-2 for procedure).
c) Disconnect the wire connection and remove
the 4 screws.
Wire connection
4 screws
Fan cover
Fan cover
Screws
(3ea)
3-11
CAUTION
Fan
Fan motor
blade
Support
Washer
Washer
Mounting
Screws
(4ea)
Fan motor
Screws
(2ea)
Cavity
Nut
Inner Outer