Belnick HL-0001-GG Assembly Instructions

Thank you for your purchase!
Mid-Back Mesh
Multifunction Executive
Swivel Ergonomic Office
Chair with Adjustable Arms
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all
of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent
scratching during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or
components may result.
Warning:
CHOKING HAZARD
- Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware
(where included) to help prevent the unit from tipping and causing accidental injury, instability, death or
damage. The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult
supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety
Wall Straps suitable for the unit weight and wall materials (if not included) should be purchased and
installed.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/HL-0001-GN-GG.pdf
Customer Service Email: CustomerExperience@belnick.com | Phone: 866-552-2810
HL-0001-GG / HL-0001-DK-GY-GG / HL-0001-GY-GG / HL-0001-BL-GG / HL-0001-GN-GG
HL-0001-OR-GG / HL-0001-PUR-GG / HL-0001-WH-GG / HL-0001-RED-GG / HL-0001-YEL-GG