Table of Contents
Advertisement
4.3.5.
Lift the machine and place it in it's intended position. Mark the floor fixing positions through the holes in the floor fixing points.
see 23 and 24 below.
4.3.6.
Lift the machine to one side and drill the floor to take suitable anchor bolts.
Lift the machine back into position and secure it with the chosen fixings.
Note: Floor fixings are not provided.
4.3.7.
Stop rod and bracket
4.3.7.1.
Screw the stop rod into the front of the vice as shown above in Fig.4 - 18.
slide the stop bracket (17) onto the stop rod in the orientation shown.
4.3.8.
Cleaning off protective coatings
4.3.8.1.
clean protective oils from the painted and unpainted surfaces of the
machine using a suitable detergent and a dampened cloth. thoroughly
dry the surfaces afterwards.
4.3.9.
Making the electrical connection.
4.3.9.1.
connect the machine to the mains power supply as described in section 1.
1
Vice handwheel
2
Vice quick lock lever
3
Blade tension
adjustment wheel
4
Handgrip control
5
microswitch
6
Fixed blade guide
7
Blade
8
Coolant valve
9
mains power switch
10 Power lamp
11 option switch
12 emergency off
13 ON/OFF Switch
14 Bow weight adjuster
15 Auto off limit switch
16 Bow damper cylinder
17 stop bracket
18 Stop rod
19 coolant pump
20 Lifting hole
21 lifting hole
22 stand front panel
23 Floor fixing point
24 Floor fixing point
25 stand end panel
26 Access panel fixing
27 Access panel
28 Vice locking lever
29 Blade direction symbol
30 Adjustable blade guide
31 Blade safety guard
© Jack sealey limited
Original Language Version
Fig.3
Fig.4
sM354CE | Issue:4 (H,F) 16/02/18
Advertisement
Table of Contents
