Stanley STN 265 W Manual page 11

the appliance but contact your service centre for
repair.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service centres or similarly
quali ed people in order to avoid a hazard.
If an extension cord is used, the plug and socket must
be of watertight construction.
Before vacuuming liquids, check the oat functions
correctly. When vacuuming liquids, and when the
tank is full, a oat closes the suction opening, and the
vacuum operation is interrupted. Then switch o the
machine, disconnect the plug and empty the tank.
Regularly clean the water level limiting device ( oat)
and examine it for signs of damages.
If the machine overturns, it would be recommended
to stand it up before switching o .
If foam or liquid escape from the appliance, switch o
immediately.
The equipment should not be used to vacuum wa-
ter from containers lavatories, tubs, etc.
Aggressive solvents or detergents should not be
used.
Service and repairs must be carried out by quali ed
personnel only. Only use manufacturer original spare
parts for service repair.
The manufacturer cannot be held responsible for any
damage/injury caused to persons, animals or property
caused by misuse of the appliance, not in compliance
with manual instructions.
USE
(see g. ③④⑤⑥⑦
• Be sure that switch is in o position (0) OFF and
connect the machine to a suitable socket.
• The machine must be always kept on horizontal bases,
in a safe and stable way.
• Insert the suitable lters for the proper use.
Never use the appliance without lters .
• Use the most suitable accessories for the requested
usage.
• Put switch on (I) ON position in order to start the
machine.
• When job is over, switch o (0) OFF and keep away the
plug from the socket.
• If the appliance is used with especially ne dust
(size below 0.3 µm) the lter supplied will require
cleaning more frequently. For especially demanding
applications, the use of speci c lters supplied as an
optional (Hepa) may be necessary.
⑧
lter shaker U
Pneumatic
a reduction in the suction power, operate
quickly the lter reset lever
reset the lter .
CARE AND MAINTENANCE ⑧⑨⑩⑪
The unit is maintenance-free.
• Clean the exterior part of the machine with a dry
• Move the appliance only by catching the carrying
• Store the appliance and the accessories in a dry safe
FILTER CLEANING R1 - R2
1- Remove the lter
2-
WARRANTY CONDITIONS
All our machines are subjected to strict tests and are co-
vered against manufacturing defects in accordance with
applicable regulations. The warranty is e ective from
the date of purchase.
The following are not included in the warranty: - Parts
subject to normal wear. - Rubber parts, charcoal, lters
and the accessories and optional accessories. - Acciden-
tal damage, caused by transport, neglect or inadequate
treatment, incorrect or improper use and installation
failing - The warranty shall not cover any cleaning ope-
rations to which the operative components may be
subjected, such as clogged nozzles and lter blocked
due to limestones.
the law (in accordance with the EU Directive 2002/96/EC
of 27 January 2003) prohibits you from disposing of this
product or its electrical / electronic accessories as mu-
nicipal solid waste and obliges you to make use of the
appropriate waste collection facilities.
The product can be disposed of by returning it to the
: If there should be
distributor when a new product is purchased. The new
product must be equivalent to that being disposed of.
U
several times to
The machine shall be disconnected from its power
source, by removing the plug from the socket-outlet,
during cleaning or maintenance
cloth.
handle located on the motor head.
place, out of the reach of children.
Before emptying the tank, switch o the machine and
disconnect the plug from the socket outlet.
Filter shaker
Once the lter has been cleaned, check whether it
is suitable for further use. If it has been damaged or
broken, replace it with an original lter.
DISPOSAL WEEE
As the owner of electrical or electronic equipment,
11