Page 1
Heavy-Duty Compact Barrel Charcoal Grill MODEL #DGSS443CB-D / DGSS443CB Français p. 19 Español p. 37 ATTACH YOUR RECEIPT HERE Serial Number ________________________________ Purchase Date _________________________________ Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-877-447-4768, 8:00 a.m. – 4:30 p.m. CST, Monday –...
TABLE OF CONTENTS Safety Information ........................2 Package Contents ........................4 Hardware Contents ........................5 Preparation ..........................5 Assembly Instructions ........................ 6 Operation Instructions ......................... 14 Care and Maintenance ........................ 15 Warranty ............................16 Replacement Parts List ......................17 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate, or install the product.
SAFETY INFORMATION • Use caution when assembling and operating this unit to avoid cuts and scrapes from edges. • DO NOT use this product in a manner other than its intended purpose. It is NOT intended for commercial use. It is NOT intended to be installed or used in or on a recreational vehicle and/or boats.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY PART DESCRIPTION QUANTITY Right Leg - Front Temperature Gauge Wheel Axle Smoke Stack Damper Wheels Lid Handle Offset Smoker Box Support Smoke Stack Front Shelf Bracket - Left Smoke Stack Gasket Front Shelf Bracket - Right Grill Body Front Shelf Side Handle...
ASSEMBLY INSTRUCTIONS CAUTION: This unit is HEAVY! Do not attempt to handle this unit without assistance! Pre-installed Remove the pre-installed bolt and washer from Hardware the left lid hinge on the grill body (G) and slide the lid (A) off the grill body hinges. Attach the left front leg (L) and right front leg (N) using four M6 x 12 bolts (AA), four M6 nuts (BB) and four M6 flat washers (CC) per leg.
Page 7
ASSEMBLY INSTRUCTIONS Before attaching the rear legs, insert the bottom shelf (K) posts into the holes located on all four legs. WIth the bottom shelf (K) securely in place, attach the left rear leg (J) and right rear leg (M) using four M6 x 12 bolts (AA), four M6 nuts (BB) and four M6 flat washers (CC), per leg.
Page 8
ASSEMBLY INSTRUCTIONS Attach side handle (H) to the left side of the grill body (G) using four M6 x 12 bolts (AA) and four M6 nuts (BB). Hardware Used M6 x 12mm Bolt M6 Nut Place the smoke stack gasket (F) between the grill body (G) and the smoke stack (E) and attach using four M6 x 12 bolts (AA) and four M6 nuts (BB).
Page 9
ASSEMBLY INSTRUCTIONS Attach the smoke stack damper (C) using the pre-installed spring and nut. Insert the end of the grease cup support (I) into the hole located on the bottom of the smoker body (G). Thread the support through the hole until the support is hanging as shown.
Page 10
ASSEMBLY INSTRUCTIONS Attach the right shelf bracket (S) to the grill body (G), using two M6 x 12 bolts (AA) and two M6 nuts (BB), and insert the shelf support wire into the bracket, as shown. Insert the shelf supports into the left shelf bracket (R), before securing the bracket with two M6 x 12 bolts (AA) and two M6 nuts (BB).
Page 11
ASSEMBLY INSTRUCTIONS Attach the lid assembly (A) to the hinges on the Pre-installed grill body (G) using the pre-installed bolt Hardware and washer. Attach the side damper plate (V) to the inside of the the access door (W) using one M6 x 12 bolt (AA) and one M6 lock nut (EE).
Page 12
ASSEMBLY INSTRUCTIONS Screw one M6 x 14 shoulder bolt (FF) into the grill body (G). Attach the access door (W) to the grill body (G) by sliding the hinge rods into the hinge openings on the grill body (G). Latch the access door (W) by pivoting the door latch (U) onto the M6 x 14 bolt on the grill body (G).
Page 13
Attach the offset support bracket (Q) to the right front (N) and rear leg (M) using two M6 x 12 bolts (AA). Note: This bracket is used to support Dyna-Glo smoker box model DGSS287CB-D (Sold Separately) Hardware Used M6 x 12mm...
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-877-447-4768, 8:00 a.m. – 4:30 p.m. CST, Monday – Friday or email customerservice@ghpgroupinc.com. PART DESCRIPTION PART # PART DESCRIPTION PART # Lid assembly (without Wheel axle 70-01-596 Wheel - Left/Right(1pc.) 70-01-516 Dyna Glo badge and Offset smoker...
Page 15
REPLACEMENT PARTS LIST 70-10-596 Printed in China...