AEG LF6ES8431A User Manual page 14

14 www.aeg.com
For more details, refer to Stand-by
paragraph in Daily Use chapter.
6.2 Introduction
The options/functions are
not selectable with all
washing programs. Check
the compatibility between
options/functions and
washing programs in the
"Program Chart". An option/
function can exclude another
one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
6.3 Temp.
When you select a washing program,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
and
heat the water.
6.4 Spin
When you set a program, the
appliance automatically sets the
maximum spin speed allowed.
Touch repeatedly this button to:
• Decrease the spin speed.
The display shows only
the spin speeds available
for the set program.
• Activate the Rinse Hold option. The
final spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing program ends with water in
the drum.
The display shows the indicator
The door stays locked and the drum
turns regularly to reduce creasing. You
, the appliance does not
must drain the water to unlock the
door.
If you touch the Start/Pause button,
the appliance performs the spinning
phase and drains the water.
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the Extra Silent option. The
intermediate and the final spinning
phases are suppressed and the
programme ends with water in the
drum. This helps to reduce creasing.
The display shows the indicator
The door stays locked. The drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
As the program is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programs the rinses are
performed with more water.
If you touch the Start/Pause button,
the appliance performs the only
draining phase.
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the drain-only option
(Skipping the wash, rinse and spin
phases): Only Drain.
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator
spin) and the indicator
• Activate the spin-only option
(Skipping the wash and rinse
phases): Only Spin.
.
.
(no
.