Table of Contents
Advertisement
10
www.aeg.com
Make sure that the drain
hose end is not immersed in
the water. There may be a
return of dirty water into the
appliance.
3. To a stand pipe with vent-hole -
Insert the drain hose directly into a
drain pipe. Refer to the illustration.
The end of the drain hose
must always be ventilated ,
i.e. the inner diameter of the
drain pipe (min. 38 mm -
min. 1.5") must be larger
than the external diameter
of the drain hose.
4. If the end of the drain hose looks like
this (see the picture), you can push it
directly into the stand pipe.
5. Without the plastic hose guide, to
a sink spigot - Remove the plastic
membrane from the sink trap spigot.
6. Connect the drain hose to the spigot
and tighten it with a clamp.
1
ø16
2
W011
7. Position the hose directly to a built-
in drain pipe in the room wall and
tighten it with a clamp.
Advertisement
Table of Contents
