Table of Contents
Advertisement
Chapter2
System Utilities
Most systems are already configured by the manufacturer or the dealer. There is no need to run Setup when
starting the computer unless you get a Run Setup message.
The Setup program loads configuration values into the battery-backed nonvolatile memory called CMOS
RAM. This memory area is not part of the system RAM.
NOTE: If you repeatedly receive Run Setup messages, the battery may be bad/flat. In this case, the system
cannot retain configuration values in CMOS.
Before you run Setup, make sure that you have saved all open files. The system reboots immediately after
you exit Setup.
17
Hide quick links:
Advertisement
Table of Contents
