EAntenna 50LFA10 Manual page 11

Guy joint in the Boom
Step 1
Pass the end of the rope Mastrant P5 once or twice through the hole in the
ring and attach the cable clamp firmly with maximum pressure.
Threadhook
Boom
For increased wind resistance, this antenna includes an anchor system for
better conservation before the Climatological.
The guys support must be at least 100cm apart on the plate that holds the
boom, so you can have enough angle to make the tension force the ropes, so
this system function can be applied.
The first step is to place the boom in the ring M6x30mm with nut on each side.
Step 3
Once done Step 1, insert the ring by screwing on the 2 threaded studs that
are in the boom to reach the top of the upper nut. Place the other washer
and nut with your fingers to get the most you can with your hand. After a key
10, the first torque nut is nearer to the pin and then the bottom.
When it is finished, we continue to Step 3.
Ring 6 x 30mm
Boom
ENGLISH
Step 2