Listening To The Radio - Jensen JEP-750 User Manual

4.P ress the MODE button after the hour is set, Minute digits flashing to
prompt for input.
5.T ap the TUNE
hold the buttons to speed up the forward or reverse scanning of the digits.
6.P ress the MODE button again to finish clock setting.
Note: If the unit was reset or if you are charging a completely dead
battery, you need to set the clock again.
1.P ress the
2.T ap the MODE button to select AM/FM/Weather band in below
sequence. The radio indicator displays.
3.T o manually tune to a desired station, repeatedly tap the TUNE
button.
4.T o automatically search for stations with strong signals, press and hold
the TUNE
scan then release the button. The tuner will stop on the first strong
signal it finds.
5.P ress VOLUME + / - button to obtain the desired sound level.
6.P ress the
listenning. The LCD backlight will automatically turns off after 20
seconds approximate.
Notes:
Manual tune to select weaker stations that might be skipped during
automatic tuning.
If the automatic tuning does not stop on the exact frequency of the
station, for example, it stops on 88.9 MHz instead of 88.8 MHz, use the
manual tuning method to "fine tune" to the exact frequency of the
desired station.
In power on mode, the LCD backlight will automatically turn off for power
saving if no buttons are pressed within a 20 seconds period of time.
HINTS FOR BEST RECEPTION:
The AM antenna is located inside the cabinet of the unit. If AM reception
is weak, change the position of unit until the internal antenna picks up
the strongest signal.
To insure maximum FM tuner reception, the Telescopic Antenna should
be fully extended and rotated to obtain the best possible station reception.
button repeatedly to set the minute value. Press and

LISTENING TO THE RADIO

button to turn on the unit, LCD backlight turns on.
AM FM
button until the frequency digits on display begins to
b utton on main unit to turn unit into standby mode after
WB ALT(WB Alert)
E9