Advertisement
GENERAL
ACTUATOR
1. Pivot Broom head until the actuator can be
attached to the Broom head frame.
2. Secure motor end (motor facing right) of
actuator to Broom head frame with the cap
screw and locknut. Attach the shaft end of the
actuator to the tank / frame mount with the cap
screw, bushing and locknut.
WARNING
SET-UP INSTRUCTIONS
OPERATING INSTRUCTIONS
Quick Pins
MAINTENANCE
BROOM CONTROL BOX AND
WIRING
1. Attach Broom control box to the steering
column with clamp, gaskets, washers and nuts
about 6 inches below steering wheel.
2. Route the actuator wire through the steering
column and connect to actuator.
3. Remove the Tractor instrument panel cover.
4. Route the power wires through the steering
column and frame to the instrument panel and
attach the negative wire (black) to the common
ground terminal and the positive wire (red) to
the rear terminal of the fuel gauge. Reinstall
cover.
OPERATION
Advertisement
