Rapid Heating; Cleaning; Cleaning Agents - Bosch HXU09AH50A Instruction Manual

Rapid heating

With Rapid heating, you can shorten the heat-up time.
Then, for best results, use:
<
3D hot air
■
%
Top/bottom heating
■
Only use Rapid heating when a temperature of over
100 °C has been selected.
To achieve an even cooking result, do not place your
food into the cooking compartment until Rapid heating
is complete.
Set the function selector to
1.
Use the temperature selector to set the temperature.
2.
The oven will start heating after a few seconds.
Once Rapid heating is complete, an audible signal will
sound. Place your food in the cooking compartment.
F
.
DCleaning
W ith good care and cleaning, your appliance will retain
C l e a n i n g
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.

Cleaning agents

Damage to the various different surfaces caused by
using the wrong cleaning agent can be avoided by
observing the following instructions.
When cleaning the hob do not use
undiluted washing-up liquid or dishwasher detergent,
■
scouring pads,
■
abrasive cleaning agents such as oven cleaner or
■
stain remover,
high-pressure cleaners or steam jets.
■
Do not clean individual parts in the dishwasher.
■
When cleaning the oven do not use
sharp or abrasive cleaning agents,
■
cleaning agent with a high alcohol content,
■
scouring pads,
■
high-pressure cleaners or steam jets.
■
Do not clean individual parts in the dishwasher.
■
Wash new sponges thoroughly before first use.
:
Warning – Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.
Zone Cleaning agent
Stainless steel sur- Hot soapy water:
faces* Clean with a dish cloth and dry with a soft
cloth. On stainless steel surfaces, always wipe
(depending on appli-
parallel to the natural grain. Otherwise, you
ance model)
may scratch the surface. Remove patches and
splashes of limescale, grease, starch and albu-
min (e.g. egg white) immediately. Corrosion
can form under such patches and splashes.
Special care products suitable for hot stainless
steel surfaces are available from our after-
sales service and from specialist retailers.
Apply a thin layer of care product with a soft
cloth.
Enamel, painted, plas- Hot soapy water:
tic and screen-printed Clean with a dish cloth and dry with a soft
surfaces* cloth. Do not use glass cleaner or glass scrap-
ers for cleaning.
(depending on appli-
ance model)
Control panel Hot soapy water:
Clean with a dish cloth and dry with a soft
cloth. Do not use glass cleaner or glass scrap-
ers for cleaning.
* Optional (available for some appliances, depending on the appliance
model)

Cleaning

en
19