Advertisement
Components
1
5
T Measure Point
Layout Modules
1
Clean and remove all debris
from the inside of the channel
letter before you begin.
4
Use rivets, screws, or silicone
to secure at least every fifth
LED module within the channel
letter. Use #6 (M3) or #8 (M4)
pan headed metal screws,
1/8-inch (3.2 mm) rivets, or
silicone.
2
3
4
C
2
Measure and cut Tetra LED
strip to the appropriate length
for each letter. Cuts can be
made between any of the
modules.
5
Drill a 1/4-inch (6.4 mm)
hole near the LED strip and
grommet the hole for supply
wire access.
NOTE: For halo-lit applications LED modules should be mounted on UL
recognized clear acrylic or polycarbonate. The light output from the LED
system should be directed back into the sign enclosure. This will allow for
uniform backlighting of the sign and will provide simple mounting.
1
UL approved 18 AWG (0.82 mm
2
UL approved 22-14 AWG (0.33-2.08 mm
connectors or 22-18 AWG (0.33-0.82 mm
in-line/IDC connectors
3
#6 or #8 (M3 or M4) screws, 1/8 inch (3.2 mm)
rivets, or electronic grade silicone or equivalent
4
Tetra
®
12 Volt Power Supply
5
®
Tetra
Wet Location miniMAX LED modules
3
Remove tape backing and
stick LED modules into place.
Continue until you have
reached the end of the strip.
6
Clean and remove all debris
from the inside of the channel
letter. Replace sign face.
) supply wire
2
) wire
2
)
2
Advertisement
