Table of Contents
Advertisement
ENGLISH
PARTS
1. On/off switch
2. Adjustable zoom wheel
3. Length position indicator
4. Charging indicator
5. Stubble comb (1-5mm)
6. Short length adjustable comb (1.5-
CHARGING YOUR APPLIANCE
Before using your trimmer for the first time, charge for 16 hours.
1. Ensure the product is switched off.
2. Connect the charging adaptor to the product and then to the mains.
3. When charging, the charge indicator light will light up. The light will go out when
charging is complete.
•
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
•
To preserve the life of your batteries, let them run out every 6 months then recharge for
16 hours.
•
On a full charge, your beard trimmer will run for up to 90 minutes of cordless usage.
CORDED
•
Connect the appliance to the mains and turn on.
•
We recommend you let the product charge for a few minutes before using corded.
CAUTION: Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
•
Cordless use – when the product is switched on and fully charged it can be used in
cordless mode for up to 90 minutes.
•
Switch the product on by sliding up the on/off switch.
•
Always comb your beard or moustache with a fine comb before you start trimming.
•
If you wish to trim your beard hair between 1.5-18mm – attach the short length
adjustable comb.
•
For maintaining and trimming longer beard length between 20-35mm attach the XL
adjustable comb.
•
To attach a comb, first ensure the adjustable zoom wheel is set to 1. Then slide on the
desired comb so that the comb rails align into the slots found at the top of the trimmer
head.
4
18mm)
7. XL adjustable comb (20-35mm)
8. Adaptor (not shown)
9. Pop-up trimmer
10. Travel pouch (not shown)
Advertisement
Table of Contents
