Table of Contents
Advertisement
Problem
Temperature cannot be set.
dEMo appears on the display.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
22
Possible cause
The "FastFreeze function" or "In-
tensiveCooling function" is
switched on.
The appliance is in demonstration
mode.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
The door has been opened often. Open the door only if necessary.
The "FastFreeze function" or "In-
tensiveCooling function" is
switched on.
There is no cold air circulation in
the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
3. If necessary, replace the defective door
Solution
Switch off "FastFreeze function" or "In-
tensiveCooling function" manually, or
wait until the function resets automat-
ically to set the temperature. Refer to
"FastFreeze function" or "Intensive-
Cooling function".
Keep the OK pressed for approxi-
mately 10 seconds until a long sound
is heard and display shuts off for a
short time.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Add less food products at the same
time.
Refer to "FastFreeze function" or "In-
tensiveCooling function".
Make sure that there is cold air circu-
lation in the appliance.
instructions.
gaskets. Contact the Authorised Service
Centre.
Fridge Freezer User Manual
Advertisement
Table of Contents
