John Lewis JLBIFF1821 User Manual page 21

Problem
There is too much frost and ice.
The compressor does not start im-
mediately after pressing the "Fast-
Freeze" or "IntensiveCooling", or
after changing the temperature.
Water flows on the rear plate of
the refrigerator.
Water flows inside the refrigerator. Food products prevent the water
Water flows on the floor.
Fridge Freezer User Manual
Possible cause
Many food products were put in
at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly.
The "FastFreeze function" or "In-
tensiveCooling function" is
switched on.
The door is not closed correctly
or the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Appliance is fully loaded and it is
set to the lowest temperature
Temperature set in the appliance
is too low and the ambient tem-
perature is too high.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost melts on the rear
plate.
to flow into the water collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
Solution
Wait few hours and then check the
temperature again.
Refer to climate class chart on the rat-
ing plate.
Allow food products to cool to room
temperature before storing.
Refer to "Closing the door".
Refer to "FastFreeze function" or "In-
tensiveCooling function".
Refer to "Closing the door".
Position the water drainage plug in the
correct way.
Set a higher temperature. Refer to
"Operation".
Set a higher temperature. Refer to
"Operation"
Refer to "Operation" .
The compressor starts after a period
of time.
This is correct.
Make sure that food products do not
touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to the
evaporative tray.
21