Interchangeable lens for digital camera (38 pages)
Summary of Contents for Panasonic ET-D3LET30
Page 1
ENGLISH ET-D3LEW10 ET-D3LET30 ET-D3LET40 Thank you for purchasing this Panasonic product. ■ To ensure correct use of this lens, please read the operating instructions supplied with the lens and the projector carefully. ■ Before using this product, be sure to read “Read this first!” ( ...
Read this first! Always follow these precautions WARNING: Do not look at or place your skin into the light emitted from the lens while the projector is being used. Doing so can cause burns or loss of sight. z Strong light is emitted from the projector’s lens. Do not look at or place your hands directly into this light.
Models other than the above may also be supported. Refer to the operating instructions for your projector or the Panasonic website (https://panasonic.net/cns/projector/). z If the projector you are using is PT-RQ32K / PT-RZ31K / PT-RS30K / PT-RZ21K / PT-RS20K, you may not be able to use the projection lens depending on main version of the firmware.
Preparation Before replacing the projection lens Return the projection lens to the home position before replacing or removing it. For details on how to return the lens to the home position, refer to the operating instructions of the projector. Attention z Make sure that the projector power supply is switched off before attaching or detaching the projection lens.
Preparation (continued) Peripheral focus adjustment function (ET-D3LEW10) When you change the size of the projected image, the focal balance between the center and peripheral areas of the screen may shift. This shift in balance tends to increase proportionally with smaller throw ratios. The ET-D3LEW10 is equipped with a peripheral focus adjustment function to correct the shift in focal balance between the center and peripheral areas of the screen.
Preparation (continued) Lens calibration Perform lens calibration after attaching the lens. The illustrations in this procedure depict use of the ET-D3LEW10 as an example. Press the <MENU> button. PROJECTOR SETUP PROJECTOR ID Use the ▲ and ▼ buttons to PROJECTION METHOD select [PROJECTOR SETUP], LENS and press the <ENTER>...
Lens shift ranges After moving the lens to the home position according to “Lens calibration” on page 7, you can use the position of the projected image at that position (i.e., the standard projection position) as a basis, and use the lens shift adjustment function on the projector to adjust the position of the projected image within the respective lens shift ranges.
Specifications Check the specifications of each projection lens, and use the appropriate lens for your intended use. Model No. ET-D3LEW10 ET-D3LET30 ET-D3LET40 F value 26.6 mm (1-1/16") - 50.4 mm (1-31/32") - 96.6 mm (3-13/16") - Focal Length (f) 36.4 mm (1-7/16") 98.0 mm (3-27/32")
Page 11
Dimensions (continued) Model number Dimensions ET-D3LET40 279 (10-31/32") ENGLISH-11...