Device Layout - Binary B-230-HDSPLTR-1x8 Installation Manual

4. DEVICE LAYOUT

A
HDMI OUT 1 HDMI OUT 2
A. HDMI Output 1- 8
Connect HDMI cables to local display
ON
B. HDMI Input
OFF POWER IN
Connect HDMI cable from source
C. Power Supply (5V DC)
Connect the included V power supply to this port
HDMI OUT 1 HDMI OUT 2
D E
ON
OFF POWER IN
F
D. Power On/Off Switch
Lights up blue when power is on and lights up red when in stand-by.
E. Power LED
Indicates that device is receiving power
F. Input LED
Indicates signal transfer over the input ports
G. LEDs for Outputs 1 through 8
Indicates signal transfer over output ports
H. Dip Switches
AUTO EDID selects the lowest common EDID between the two output ports
to send to the source
Output EDID reports the EDID from output 1 to the source
I. Update (mini USB port)
To connect mini USB cable when updating firmware
HDMI OUT 3 HDMI OUT 4 HDMI OUT 5
OUT 1 OUT 2 OUT 3 OUT 4 OUT 5 OUT 6 OUT 7 OUT 8
HDMI OUT 3 HDMI OUT 4
G
OUT 1 OUT 2 OUT 3 OUT 4 OUT 5 OUT 6 OUT 7 OUT 8
HDMI OUT 6 HDMI OUT 7
On
O
HDMI OUT 5 HDMI OUT 6 HDMI OUT 7
6
B
HDMI OUT 8 HDMI IN
1 2 3 4
EDID
HDMI OUT 8 HDMI IN
H
1 2 3 4
On
O
EDID
C
+5 VDC
UPDATE
+5 VDC
I
UPDATE