Table of Contents
Advertisement
3/8 LOCK NUT
SUPPORT BRACKET
10,3MM (13/32)
FLAT WASHER
3/8 X 63,5MM HEX BOLT
3/8 X 19MM HEX BOLT
SUPPORT BRACKET
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to float with
the mower deck when moving on uneven terrain.
DISCHARGE CHUTE
TO ASSEMBLE BAGGER (See Figs. 8 - 10)
•
Unfold bag by pivoting front bagger tube all the way
forward and pressing the bottom vinyl binding onto the
tube.
FRONT BAGGER TUBE
VINYL
BINDING
•
Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
•
Press the vinyl bindings onto the sides of front bagger
tube.
ASSEMBLY
Fig. 6
HOOK
BACKPLATE
SLOT
Fig. 7
Fig. 8
RE TAIN ER
SPRING
VINYL
BINDING
RE TAIN ER
SPRING
NOTE: For tractors with an electric dump system, refer to
the kit instructions for more assembly procedures.
MANUAL BAGGER DUMPING ONLY:
•
Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin 10 x 44mm and secure
with retainer clip.
•
Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in
order to use the handle to clear the chute in the event it
has become clogged.
DUMP HANDLE
TUBE
CLEVIS PIN
3/8 X 1-3/4
RE TAIN ER CLIP
CAP
BAGGER ADJUSTMENT (See Fig. 11 & 12)
For proper bag function and appearance, it may be nec es-
sary to adjust the bagger assembly. There should be 6mm
(1/4")-9mm (3/8") gap between the bagger top and fender
and the bagger top surface should be even with the top
surface of the fender. To adjust bagger position:
8
SPREADER BARS
(Inside of bag)
VINYL
BINDING
Fig. 9
Fig. 10
Hide quick links:
Advertisement
Table of Contents
