Page 1
Model II GW1104-4D(3IN1) (4 RS-485/422/232 serial ports + 1 100M copper port) GW1104 Series Model III GW1104-4DI(RS-485) (4 RS-485/422 serial port with isolation + 1 100M copper port) Modbus Gateway Quick Installation Guide 【Panel Design】 Front View Model I Model II 3onedata Co., Ltd.
Page 2
Terminal block 1 for power input Grounding screw Note Before Mounting: DIP switch Don't place or install the device in area near water or Console Port moist, keep the relative humidity of the device RS-232 serial port surrounding between 5%~95% without condensation. Terminal block 2 for power input Before power on, first confirm the supported power ...
Page 3
【Power Supply Connection】 at the same time. The interface type is RJ45 and its pin 9~48VDC power supply definitions are as follows: Model I of this series provides 2-pin 5.08mm pitch terminal block, power supply range: 9~48VDC. RS-232 DSR RTS GND TXD RXD DCD CTS DTR RS-485 —...
Page 4
Indicate Description Full-load 3.00W@12VDC the device. Working environment No data or abnormal data is being Working temperature -40~75℃ Notes: TX(1-4) transmitted through serial port. Storage temperature -40~85℃ The default IP address of the device Internet access is Blinking Serial port is transmitting data. “192.168.1.254”.