Service Bulletin Inf2003-03 - Infinity INTERMEZZO 4.1t Service Manual

INTERMEZZO 4.1t
Service Bulletin INF2003-03 - June 2003
To: All Infinity Service Centers
Model: Intermezzo 4.1t
Subject: Distortion at Low Volume Levels
In the event you receive an Intermezzo 4.1t with the complaint "there is distortion at low volume levels,
particularly when higher frequencies are present", perform the following procedure:
Synopsis:
Remove three components and re-wire them in a similar circuit on the opposite side of the Feature PCB.
1) Remove the woofer grille; extract the (6) rubber grille retainers; this can be accomplished by carefully
pulling them out of their cavities with long-nosed pliers or similar tool.
2) Remove the (6) Phillips screws from the woofer trim ring.
3) Remove the trim ring with the woofer attached; unplug the two wire leads.
4) Remove the (6) Phillips screws at the rear of the enclosure, and push the amplifier assembly into the
enclosure.
5) Unplug the three connectors from the amplifier; remove the amplifier from the woofer opening.
6) Remove the 4 screws holding the front faceplate w/ controls and Feature PCB to the plastic enclosure;
pull the assembly out as far as the attached wires will allow. If the rectangular gasket bordering the
enclosure is damaged during this procedure, order Infinity part# MM0080.
7) Unplug all wire connectors on the PCB except the AC power wires, which can remain attached.
8) Remove the 2 screws holding the HP push button switch assembly to the faceplate; remove the
assembly and plastic spacers.
9) Locate and remove resistors R153 (2.2KΩ), R154 (5.6MΩ) and diode D110 (1N4148).
10) Resolder the three components together on the rear of the PCB, following the examples below: "Circuit
Equivalent", and supplied image on Page 2. Observe polarity for D110. Solder an insulated 16 - 20
gauge (0.5 to 1.0 mm
traces in the indicated areas. Add a dab of silicon sealer or equivalent adhesive to hold the
components in place on the PCB.
2
) jumper wire to the cluster of parts to complete the connection. Cut the PCB
Service Bulletin
Warranty labor rate: MAJOR repair
18