Leveling Instructions - Danby DBM187E1WDB Owner's Manual

OPERATING INSTRUCTIONS
LOCATION
• Two people should be used when moving the appliance.
• Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a
soft, dry cloth and the inside with a lukewarm wet cloth.
• Place the appliance on a fl oor that is strong enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this
can increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance
to perform improperly.
• Do not use the appliance near water, for example in a wet basement or near a sink.
• This appliance is intended for household use only. It is not designed for outside installation, including
anywhere that is not temperature controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power source, let it stand upright for approximately 6 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• This appliance is 75 cm (29.5 inches) wide by 171.2 cm (67.4 inches) high by 83.8 cm (33 inches)
deep.
• This appliance is only intended for free-standing installation. It is not intended to be built into a cabinet
or counter without following the minimum air circulation requirements.
• Minimum air circulation requirement: Allow 5 cm (2 inches) of space between the back, sides and top
of the appliance and all surrounding structures (walls, cabinets or counter tops).
• WARNING - Placing this appliance into any enclosed location with a door or without the minimal
amount of air space described above will VOID YOUR WARRANTY, increase energy usage, and
reduce this appliance's performance and lifespan.

LEVELING INSTRUCTIONS

There are adjustable legs on the bottom of the
cabinet that can be turned up or down to ensure
that the appliance is level.
1. Turn the leveling leg counter-clockwise as far as
it will go, until the top of the foot is touching the
bottom of the cabinet.
2. Slowly turn the leveling leg clockwise until the
appliance is level.
3