Hitachi NW-80ESP User Manual page 9

Installation of Washing Machine 洗衣機的安裝
1
Adjust the instability of the washing
machine with adjustable leg.
用可調機腳來調整洗衣機的不平穩。
Fixed leg
固定腳
Adjustable leg
可調機腳
Inspection of trial run 試運轉的檢查
Put some water into the washing barrel and reconfi rm its
horizontality.
在洗衣槽內放些水，請再一次確認其水平度。
The ground is level if all front, rear, left and right height difference
•
between the spinning hole and water surface are less than 3mm.
脫水孔相對於水面的高度差 (B 與 C 的差 )，如果前後左右均在 3mm 以內，
就表示地面是水平的。
■ To install the machine on an inclined fl oor, leg caps in the attached accessory kit can be used to adjust height by
connecting them to the fi xed leg.
安裝在傾斜的地面上時，請將附有的腳套套在固定腳上進行調整。
■
Confi rming the machine type of NW-80ESP/NW-70ESP, please install the water drainage hose and hang it on.
Otherwise there will be no water in washing basket.
NW-80ESP/NW-70ESP 機型確認時，請先安裝排水管並將其連起，否則洗衣槽內無法盛水。
排水管的安裝及固定方法。
How to Use the Adjustable Leg 可調機腳的使用
1
Loosen the lock nut by unscrewing
in arrow direction 1 before using the
adjustable leg to stabilize unit.
將鎖緊螺母沿箭咀方向 1 旋鬆，再旋轉可
調機腳調整機身的平穩。
Loosening
Elevating
10
10
Lock nut
Adjustable leg
Lowering
2
Please make sure of the horizontality of
the washing machine.
請確認機體的水平度。
• As shown in the fi gure, the horizontality can be easily
observed by the string used to hang an object.
如圖所示，用懸掛重物的細繩來觀察，即可輕易確認
其水平度。
It is level if the
clearance between
A and machine body
is the same with that
string
between A and the
細繩
machine body.
A 和 兩點與機體
A
之間的間隙相同，
object
即表示水平。
重物
2
After adjusting of the unit, tighten
the lock nut by screwing it in arrow
direction.
調整完畢後，將鎖緊螺母沿箭咀方向 2
旋緊。
Plastic base
Tighten the lock nut until it reaches the plastic base.
Maximum adjust able
At most 40mm
range is 40mm.
40mm
A
(front or
profi le)
（正面或
側面）
A
B C
Tightening
Lock nut
9