Advanced - Acer Ferrari 3000 Service Manual

Advanced

The Advanced menu screen contains parameters involving your hardware devices. It also provides advanced
settings of the system.
Information
Parallel port:
Mode:
Base I/O address:
Interrupt:
DMA channel
F1 Help
Esc Exit
The table below describes the parameters in the screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
Serial Port
Parallel Port
Mode
Base I/O address
Interrupt
DMA channel
36
PhoenixBIOS Setup Utility
Main Advanced
↑ ↓ Select Item
← →
Select Menu
Enables, disables or auto detects the serial port.
Enables, disables or auto detects the parallel port.
Sets the operation mode of the parallel port.
Sets the I/O address of the parallel port. This
parameter is enabled only if Mode is set to ECP or
Bi-directional. This parameter is enabled only if
Mode is set to ECP.
Sets the interrupt request of the parallel port.
Sets a DMA channel for the printer to operate in
ECP mode. This parameter is enabled only if Mode
is set to ECP.
Security
[Enabled]
[Bi-direct]
[378]
[IRQ 7]
[DMA3]
F5/F6 Change Values
Enter Select Sub- Menu
Description
Boot Exit
Item Specific Help
Configure Infrared Port
using options:
[Auto]
Disable the touchpad if an
external PS/2 mouse is
connected. Otherwise
enable the touchpad
[Both]
The touchpad is always
enabled. Any external PS/2
mouse connected will be
enabled at the same time.
F9 Setup Defaults
F10 Save and Exit
Options
Enabled
/Disabled/Auto
Enabled
/Disabled/Auto
ECP
, EPP, Normal or Bi-directional
378h
/278h/3BCH
IRQ7
/IRQ5
DMA3
/DMA1
Chapter 2