JVC AV-32Z25EUY Service Manual page 8

AV-32Z25EUY
AV-28Z25EUY
REMOVING THE CRT
∗ Replacement of the CRT should be performed by 2 or more
persons.
• After removing the cover, chassis etc.,
1. Putting the CRT change table on soft cloth, the CRT change table
should also be covered with such soft cloth (shown in Fig.5).
2. While keeping the surface of CRT down, mount the TV set on the
CRT change table balanced will as shown in Fig.6.
3. Remove 4 screws marked by arrows with a box type screw driver
as shown in Fig.6.
• Since the cabinet will drop when screws have been removed, be
sure to support the cabinet with hands.
4. After 4 screws have been removed, put the cabinet slowly on
cloth (At this time, be carefully so as not to damage the front
surface of the cabinet) shown in Fig.7.
• The CRT should be assembled according to the opposite
sequence of its dismounting steps.
∗ The CRT change table should preferably be smaller that the CRT
surface, and its height be about 35cm.
CAUTION
• The woofer unit is mounted on the TV. Always move the TV and woofer unit together when removing the TV from the box, or when
moving the woofer unit.
• If the TV is tilted during movement the woofer unit may fall. Be careful to keep the TV level when moving it.
• Do not grip the woofer unit when moving the TV.
• Do not place objects on the woofer unit duct.
8
CRT CHANGE TABLE
CLOTH
CRT
CHANGE
TABLE
CABINET
No. 52067
APPROX.
35cm
Fig. 5
CRT
BOX
TYPE
SCREW
DRIVER
Fig. 6
CRT
CRT
CHANGE TABLE
Fig. 7