Internal Speaker Failure
If internal Speakers fail, perform the following.
Figure 4-6. Internal Speaker Failure
Sound Problems
Perform the following, one at a time.
1.
Boot the computer.
2. Navigate to Start
Manager to determine that:
The device is properly installed
There are no red Xs or yellow exclamation marks
There are no device conflicts
No hardware is listed under Other Devices
3. If updated recently, roll back the audio driver to the previous version.
4. Remove and reinstall the audio driver.
5. Make sure that all volume controls are set mid range:
Click the volume icon on the taskbar
Drag the slider to 50. Confirm that the volume is not muted.
Click Mixer to verify that other audio applications are set to 50 and not muted.
4-10
Start
Check M/B SPK
cable
Check Logic
Upper/Logic
upper
Swap M/B
Control Panel
System
0
OK
Re-assemble the
NG
SPK cable to M/B
OK
Swap Logic
NG
lower/Logic upper
Device Manager. Check the Device
0
Troubleshooting