Setting A Password - Acer Aspire 7520 Service Manual

The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
Supervisor Password is
User Password is
HDD Password
Set Supervisor Password
Set User Password
Set HDD Password
Password on Boot
NOTE: When you are prompted to enter a password, you have three tries before the system halts. Don't forget
your password. If you forget your password, you may have to return your notebook computer to your
dealer to reset it.

Setting a Password

Follow these steps as you set the supervisor, user, or hard disk password:
1. Use the w and y keys to highlight the Set Supervisor Password parameter and press the e key. The
Set Supervisor Password box appears:
2. Type a password in the "Enter New Password" field. The password length can not exceed 8 alphanumeric
characters (A-Z, a-z, 0-9, not case sensitive). Retype the password in the "Confirm New Password" field.
IMPORTANT: Be very careful when typing your password because the characters do not appear on the
screen.
3. Press e. After setting the password, the computer sets the Supervisor Password parameter to "Set".
4. If desired, you can opt to enable the Password on boot parameter.
5. When you are done, press u to save the changes and exit the BIOS Setup Utility.
Chapter 2
Description
Shows the setting of the Supervisor password
Shows the setting of the user password.
Shows the setting of the hard disk password.
Press Enter to set the supervisor password.
When set, this password protects the BIOS
Setup Utility from unauthorized access. The
user can not either enter the Setup menu nor
change the value of parameters.
Press Enter to set the user password. When
user password is set, this password protects
the BIOS Setup Utility from unauthorized
access. The user can enter Setup menu only
and does not have right to change the value of
parameters.
Press Enter to set the hard disk password.
When set, this password protects the BIOS
Setup Utility from unauthorized access. The
user can not either enter the Setup menu nor
change the value of parameters.
Defines whether a password is required or not
while the events defined in this group
happened. The following sub-options are all
requires the Supervisor password for changes
and should be grayed out if the user password
was used to enter setup.
Option
Clear
or Set
Clear
or Set
Clear
or Set
Disabled
or Enabled
45