Wavion WBSn-2400-O Quick Installation Manual

Wavion WBSn-2400 Quick Installation Guide
Note: Unless otherwise specified, the product name WBSn-2400 refers to both the WBSn-2400-O and WBSn-2400-S base stations.
Package content
• WBSn-2400 base station unit
• PoE injector unit
• Post-clamp
• Two steel bands
• 4 screws, each with attached spring and flat washers
• Iron security cable
•
Plastic cap and cap cover
• 3 antennas (Omni only)
• Waterproof sealing tape for IP67 (band to sealing rubber)
(Omni only)
Important Information
Warnings
•
The Wavion WBSn-2400 must be used only with Wavion-
approved components and antennas.
•
Only experienced installation professionals who are familiar
with local building and safety codes and are licensed,
wherever applicable, by the appropriate government
regulatory authorities, should install outdoor units and
antennas.
•
Modifying the operating frequency or enhancing the transmit
output power through the use of external amplifiers or other
equipment is illegal.
Pole Installation
1. Attach the post-clamp to the post, and close and tighten the steel bands.
2. Attach the WBSn-2400 unit to the post-clamp, using screws and washers, and
tightening the screws using a 13 mm diameter ratchet key.
Connecting Power and DATA to the WBSn-2400
Step-by-step instructions for connecting power and data to the WBSn-2400 are provided overleaf.
•
You must always install an external grounding wire, as shown in the first instruction over the
page. Ensure that you have completed grounding before you connect power to the WBSn-2400.
•
This is not a mid-span powered device. Do not attempt to daisy-chain PoE devices.
Warning
For WBSn-2400-O only:
1. After the antenna is connected, use the supplied isolation tape to cover the N-Type connectors
and the lower part of the antennas.
Sealing the
2. Cut 18 cm of the attached splicing tape and ensure that the sticky side of the tape is exposed.
antennas
3. Stretch and wrap the tape in an even, half-lapping manner around the antenna and N-Type
connector. Cover this with a layer of vinyl plastic tape.
For further information, please contact Wavion Technical Support at:
Additional equipment required
• Ethernet cable (outdoor CAT5e 4-pair data cable, with
RJ45 connectors)
Note: Maximum cable length: 100 meters
• Ground cable
•
Lightning protection
•
1"-6" diameter pole (on which to mount the unit)
Note
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
•
This device may not cause harmful interference
•
This device must accept any interference received, including
such interference that may cause unrequired operating effects.
support@wavionnetworks.com