Removing The Speaker Module - Acer Aspire 4810TZ Series Service Manual

12. Disconnect the touchpad cable from the touchpad board; then carefully pry loose and remove the touch
pad board
WARNING:The touchpad board is glued to the upper case, only remove the touchpad board if it is defective.
Note: Circuit boards >10 cm² has been highlighted with the yellow rectangle as above image shows.
Please detach the Circuit boards and follow local regulations for disposal.

Removing the Speaker Module

1. See "Removing the Battery Pack" on page 44.
2. See "Removing the Lower Cover" on page 45.
3. See "Removing the Lower Cover" on page 45.
4. See "Removing the Optical Drive Module" on page 46.
5. See "Removing the DIMM" on page 46.
6. See "Removing the Hard Disk Drive Module" on page 47.
7. See "Removing the SSD Module" on page 48.
8. See "Removing the RTC Battery" on page 48.
9. See "Removing the Keyboard" on page 51.
10. See "Removing the WLAN Board Module" on page 52.
11. See "Separating the Upper Case from the Lower Case" on page 53.
Chapter 3 57