Table of Contents
Advertisement
38
www.electrolux.com
Loosen the ring nut to angle the hose to
the left or right depending on the position
of your water tap. Do not place the inlet
hose downwards. After positioning the
inlet hose, be sure to tighten the ring nut
again to prevent leaks.
35°
11.4 Water Drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink, using
the plastic hose guide supplied with the
machine.
Fitting Hose Guide
1.
Pull apart to
insert hose.
2.
45°
Hose
Guide
pull hose
Adjust length to suit
trough.
In this case, make sure the end
cannot come unhooked when the
machine will be emptied. This could
be done by tying it to the tap with a
piece of string or attaching it to the
wall.
In a sink, drain pipe branch.
This branch must be above the trap
so that the bend is at least 60 cm
above the ground.
bend
hose
Max.
90 cm
Min.
60 cm
Push the drain hose onto the spigot
and secure with a clip, ensure a
loop is formed in the drain hose to
prevent waste from the sink
entering the appliance.
Advertisement
Table of Contents
