Water Hardness & Regeneration Settings - Beko DFN28321W User Manual

Preparation
2. Turn the salt reservoir lid counter
clockwise to open it (A, B).
C
Salt reservoir will fill with water
when you start the product.
Therefore, add the softening
salt before starting the
machine.
C
Before initial use, fill the water
softening system with 1 litre of
water (C).
3. Fill the salt reservoir with salt by using
salt funnel (D). To speed up dissolution rate
of salt in water, stir it with a spoon.
C
You can put about 2 kg of
Dishwasher salt into the salt
reservoir.
Dishwasher / User's Manual
4. Replace the lid and tighten it securely
when the reservoir is full.
5. If you will not start a washing programme
immediately after adding the salt, run the
machine empty in the shortest programme
to dissolve and wash away the scattered
salt in the machine.
Water hardness &
regeneration settings
The dishwasher requires lime free water.
Hard water leaves watermarks on your
dishes. Your dishwasher has a special
water softening system to remove the
hardness of the tap water. Setting this
system correctly will increase the washing
effectiveness.
To find out the hardness level of water in
your area, contact your local Water Board or
Determine water hardness level by the help
of test strip provided.
If you move to a different location,
the level of water hardness will
possibly be different. It is essential to
reset the water hardness in order to
obtain optimum washing efficiency.
13 / 40 EN