Connecting Bbg-1022-Fs To Your Network - Cobalt Digital Inc BBG-1022-FS Product Manual

Setup/Operating Instructions

Connecting BBG-1022-FS To Your Network

Connecting BBG-1022-FS To Network
1. Power-up BBG-1022-FS and connect Ethernet cable connection to media. Wait for BBG-1022-FS to complete booting.
Product: BBG-1022
When
2. Press and access the
server).
Note: It is recommended to now change the settings to use a static IP address of your choice. The following steps describe using
a static IP address.
Network Settings > Mode
3. In
4. Configure the following fields as desired and appropriate for your network connection (examples shown below).
Menu: Network Settings
IP: 10.99.16.105
Netmask: 255.255.255.0
Gateway: 10.99.16.1
Mode: Static
5. Press X to commit changes and exit the setup menu.
Note: Current IP address of BBG-1022-FS can now be checked from the front panel by accessing this at any point.
6. At this point, BBG-1022-FS can now be accessed with a web browser pointing to the configured address. Browse to the configured
address and check connectivity.
Web browser pointing to configured address displays BBG-1022-FS
BBG1022FS-OM (V1.4)
BBG-1022-FS ships with network protocol set to DHCP and populates its
address with an addressed allocated by your DHCP server. If your network
does not have a DHCP server, the BBG-1022-FS address field will be blank,
and a static address must then be assigned. All initial network settings are
performed using the Front Panel Display menu-accessed control (as described
on the previous page). Refer to this page for instructions of using the
front-panel menu navigation.
Access the Network Settings menu and configure network settings as follows:
... is displayed, device is ready for configuration.
Network Settings
menu. Current network settings are displayed (as configured by host DHCP
, change setting to
BBG-1022-FS PRODUCT MANUAL
Connecting BBG-1022-FS To Your Network
Mode: Static
.
3-3