Table of Contents
Advertisement
K
2. Pull the water filter (K) from the filter
holder (L).
L
Note:
To change the water filter easily, shut off
the water supply valve.
Sometimes, it is hard to disassemble the
water filter because impurities in the
water cause it to stick. If you are having
difficulties, grip the water filter firmly and
pull it out.
When you pull the water filter, a little
water can leak from the opening.
This is normal. To minimize the water
leaks, keep the filter cartridge horizontal
when pulling it.
To prevent overflow, empty the water
filter tray (M) and dry around the filter
case.
To insert the new water filter, follow the
directions below.
M
3.
Insert the new filter into the filter holder.
K
4.
Push the filter, and then turn it clockwise
until it locks.
If you have trouble inserting the water
filter because of high water pressure, shut
off the water supply valve.
5.
If you turned off the water supply, turn it
back on.
Note:
After turning on the water supply, you
should check the leaks. If leaks occur,
repeat the steps 1- 5. If leaks
persist, discontinue use and call
Hisense customer service..
Removing any residual matter inside the
water supply line after installing the water
filter
1. After the water filter is replaced,
dispense 2.5 gallons of water (flush for
approximately 5 minutes) to remove
trapped air and contaminants from
the system.
2. Additional flushing may be required in
some households.
3. Open the refrigerator door and make
sure there are no water leaks coming
from the water filter.
14
Advertisement
Table of Contents
