Hisense RF26N6AFE Use & Care Manual page 14

Freezer
Freezer Temperature
Control
You can touch the "Freezer" button to
activate the mode to control the freezer
temperature. When you press the button
continuously, the temperature will be set in
the following sequence.
Note:
If you want to exchange the "°F" to "°C",
please press and hold the "Super Cool"
and "Energy Saving" buttons for
3 seconds.
If you have set the temperature type to
Celsius, the temperature settings cycle
from -14° C and -24° C in one degree
increments.
Super Super Freeze
Freeze
If you want to decrease the time needed
to freeze products in the freezer, please
touch this button, the Super Freeze icon
" " will be illuminated, the freezer
temperature setting displays -12°F.
Super Freeze can quickly lower the
temperature and freeze your food faster
than usual. This can retain more of the
vitamins and nutrients in fresh food and
keep your food longer.
The Super Freeze mode allows you to
freeze items inside with maximum speed.
We recommend that you let the
appliance operate for 6 hours first.
Super Freeze automatically switches off
after 26 hours, and the freezer
temperature setting will revert back to
the previous setting.
When the Super Freeze function is on,
you can touch the "Super Freeze" button
again to switch off. If power cutoff
happens while Super Freeze is activated,
the Super Freeze will not remain active
after power is resupplied.
Water Filter
In general, you should change the water
filter every 6 months to ensure the highest
possible water quality.
After the refrigerator has dispensed
about 300 gallons of water, the filter icon
" " will blink, reminding you to replace
the water filter.
First of all, you need to purchase a new
water filer. You can purchase the new
filter from the retailer where you
purchased your refrigerator or the
Hisense after-sales service system.
Before that, please check that the new
filter is the same filter type that came with
your fridge and can be correctly used in
your refrigerator.
After you change the water filter, push
and hold the "Ice On/Off" buttons for 3
seconds to make the blinking stop. When
you replace the water filter, some water
may leak from the filter and lines. Please let
the water flow into a pan and wipe up any
leakage that may have occurred.
Energy
Energy Saving
Saving
Note:
The control panel will light up when the
door is open, or you touch any button.
The light will go off without touching any
buttons or if the doors have been closed
for over one minute.
When the refrigerator is powered on, all
the icons of the control panel will light up
for 3 seconds, and a buzzer sounds.
The temperature setting reverts back to
the previous setting.
12