Panasonic VL-SWD275 Instruction Manual page 13

Installing the main monitor/
extension monitor
1
Attach the mounting bracket (A) to the wall
securely.
R Install the mounting bracket on a vertical flat
wall (B).
A
C
C Screws (accessory) ´ 2
D Hole in wall E 60 mm F 83.5 mm
G 7 mm H 50 mm
2
[For power supply unit non-attached
models]
VL-SWD275BX/VL-MWD275BX etc.:
Connect the wires.
R Connect the wires correctly according to
"Wiring schematic diagram".
R How to make wiring connections
While pressing on the button (A) with a
pointed object such as a screwdriver, insert
the wire into the terminal connector (B).
(To disconnect a wire, while pressing on the
button (A), pull out the wire.)
A
B
D
C Core conductor wire at tip: 9 mm
B
D
E
F
G
H
C
D Wiring from doorphone or other device
[For power supply unit attached models]
VL-SWD275AZ/VL-MWD275AZ etc.:
Connect the DC cable and wires.
R Connect the wires correctly according to
"Wiring schematic diagram".
2-1 How to connect the DC cable
A Remove screw (A) and then remove the
terminal cover.
B While pressing on the button (B) with a
pointed object such as a screwdriver, insert
the wires of the DC cable into the terminal (the
DC cable of the power unit can be wired in the
desired direction from the 3 depressions (C))
connectors (non-polar).
C Make sure to replace the terminal cover.
2-1
B
E
D Core conductor wire at tip: 12 mm
E Wiring from power supply unit
(Example: when wiring from the right direction)
2-2
A
D
C
13