Disabling The Keypad And Scan Stop Beeper - Yaesu FT-25E Operating Manual

Advanced Operation
4. Press the [▲] or [▼] key to select one of the
modes described above.
5. Press the PTT switch to save the new setting and return to normal oper-
ation.

Disabling the Keypad and Scan Stop Beeper

An audible beep tone will sound when a keypad button is pressed, and also
when the receiver scanning stops. The beep tone operation may be changed
as shown in the below table:
Display
KEY
KEY+SC(default setting)
OFF
1. Press and hold the F key to enter the Set Mode.
2. Press the [▲] or [▼] key to select Set Mode item "5 BEEP"
3. Press the F key to enable adjustment of this Item.
4. Press the [▲] or [▼] key to select "OFF"
5. Press the [▲] or [▼] key to select one of the
modes described above.
6. Press the PTT switch to save the new setting and return to normal oper-
ation.
7. To turn the beep back on again, select "KEY" or "KEY+SC (Default setting)"
in step 4 above.
26
The beeper sounds when a keypad button is
pressed.
The beeper sounds when a keypad button is
pressed, or when the receiver scanning stops.
The beeper does not sound.
FT-25R/FT-25E Operating Manual
Description