Routine Maintenance - Shop-Vac H-8095 Quick Start Manual

Hide thumbs

Table of Contents

SHOP-VAC

Foam Sleeve

Full Polyester Sleeve

FILTER

Foam Sleeve

Full Polyester Filter

Super Performance Filter

Reusable Disk Filter

CleanStream

Abrasion

Resistant Cartridge Filter

Cartridge Filter & Ultra Web

Cartridge Filter

All Collection Bags

DAILY

Filter – Check cartridge filter for clogs or heavy

soiling and replace if necessary. Ensure that correct

filters are being used for the task – see Filters section

of instruction manual.

2. Collection Bag – If using collection filter bag, check

to ensure that there are no rips or tears in the bag

and that the bag is not full.

3. Tank – If vacuuming up wet or damp material,

empty the tank after use, as musty odors may occur

if debris is left inside.

4. Extension Cord and Plug – Check extension cord

and plug for any cuts or damage. If damaged,

replace motor housing unit.

5. Motor – If there are unusual sounds or if poor

performance occurs, the motor should be inspected

immediately by the Uline service team.

PAGE 7 OF 8

VACUUM FILTER CLEANING REFERENCE

Super Performance Filter

CLEANING INSTRUCTIONS

Rinse with water, dry and reinstall.

Brush off dirt and reinstall; if filter gets wet, rinse with water, dry and

reinstall.

Dispose of after filter develops rips or tears.

Rinse with water, dry and reinstall. Important: do not machine wash.

Clean installed filter by tapping or shaking the vacuum unit. To restore

optimum airflow, remove filter and tap end cap against a hard

surface to loosen debris. Additional debris can be removed by rinsing

outside surface of filter with running water. Avoid dampening inside of

filter. Completely air dry filter after washing. Important: DO NOT brush.

DO NOT clean filter media with abrasive materials. DO NOT scrub to

clean between pleats. This will permanently damage the filter's ability

to stop dust.

From inside of filter, rinse with water, dry completely and reinstall.

Dispose of bag when full.